Resetting The 802.1X Authentication Configuration To The Default Values; Displaying 802.1X Statistics And Status - Cisco WS-CBS3032-DEL Software Configuration Manual

Displaying 802.1x Statistics and Status

Resetting the 802.1x Authentication Configuration to the Default Values

Beginning in privileged EXEC mode, follow these steps to reset the 802.1x authentication configuration
to the default values. This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
dot1x default
Step 4 end
Step 5 show authentication interface
interface-id
Step 6 copy running-config startup-config
Displaying 802.1x Statistics and Status
To display 802.1x statistics for all ports, use the show dot1x all statistics privileged EXEC command.
To display 802.1x statistics for a specific port, use the show dot1x statistics interface interface-id
privileged EXEC command.
To display the 802.1x administrative and operational status for the switch, use the show dot1x all
[details | statistics | summary] privileged EXEC command. To display the 802.1x administrative and
operational status for a specific port, use the show dot1x interface interface-id privileged EXEC
command.
Beginning with Cisco IOS Release 12.2(55)SE, you can use the no dot1x logging verbose global
configuration command to filter verbose 802.1x authentication messages. See the
Manager CLI Commands" section on page
For detailed information about the fields in these displays, see the command reference for this release.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
9-66
Chapter 9
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the port to be configured.
Reset the 802.1x parameters to the default values.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
9-9.
Configuring IEEE 802.1x Port-Based Authentication
"Authentication
OL-13270-06