Monitoring The Ethernet Management Port; Tftp And The Ethernet Management Port; Configuring Ethernet Interfaces - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Ethernet Interfaces

Monitoring the Ethernet Management Port

To display the link status, use the show interfaces fastethernet 0 privileged EXEC command.

TFTP and the Ethernet Management Port

Use the commands in
loader.
Table 11-1
Command
arp [ip_address]
mgmt_clr
mgmt_init
mgmt_show
ping host_ip_address
boot tftp:/file-url ...
copy tftp:/source-file-url
filesystem:/destination-file-
url
1. ARP = Address Resolution Protocol.
Configuring Ethernet Interfaces
These sections contain this configuration information:
•
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
11-18
Table 11-1
Boot Loader Commands
Default Ethernet Interface Configuration, page 11-19
Configuring Interface Speed and Duplex Mode, page 11-20
Configuring IEEE 802.3x Flow Control, page 11-22
Configuring Auto-MDIX on an Interface, page 11-23
Adding a Description for an Interface, page 11-24
when using TFTP to download or upload a configuration file to the boot
Description
Displays the currently cached ARP
without the ip_address parameter.
Enables ARP to associate a MAC address with the specified IP address
when this command is entered with the ip_address parameter.
Clears the statistics for the Ethernet management port.
Starts the Ethernet management port.
Displays the statistics for the Ethernet management port.
Sends ICMP ECHO_REQUEST packets to the specified network host.
Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.
Chapter 11 Configuring Interface Characteristics
1
table when this command is entered
OL-13270-06