Configuring Snmp Rmon Alarms And Events (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 76: Configuring Nonvolatile Fields
Option
Comment
Commit Delay
Related
Documentation

Configuring SNMP RMON Alarms and Events (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the
nonvolatile commit delay configuration.
Specifies the delay time between an
affirmative SNMP Set reply and the start
of commit.
Configuring the Interfaces on Which SNMP Requests Can Be Accepted (NSM Procedure)
on page 121
You can configure SNMP remote monitoring (RMON) alarms and events to monitor
integer-valued MIB objects, standard or enterprise-specific, on the device. You can set
the alarm values against thresholds and trigger events when the thresholds are crossed.
To configure the SNMP RMON alarms and events in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand SNMP.
4.
Select Rmon.
5.
Enter the parameters as specified in Table 77 on page 126.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the SNMP settings.
Chapter 10: Configuring SNMP
Your Action
Enter a comment.
Specify the delay time, in seconds. The
default value is 5.
125