Table 42: Rib Group Fields (continued)
Option
Import Rib
Configuring Routing Tables (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the name of the routing table
into which the JUNOS software is to
import routing information. The first
routing table name you enter is the
primary routing table. Any additional
names you enter identify secondary
routing tables. When a protocol imports
routes, it imports them into the primary
and any secondary routing tables.
This feature enables you to configure routing tables. You can also configure the static,
martians, aggregate, maximum paths, maximum prefixes, multipath, or generated routes
to the routing table. If you are not adding any of those routes, then the creation of the
routing table is optional. The JUNOS software uses its default routing tables, which are
for IPv4 unicast routes,
inet.0
forwarding cache, and
inet.3
To configure a routing table in NSM:
In the navigation tree, select
1.
In the
Devices
list, double-click the device to select it.
2.
Click the
Configuration
3.
In the configuration tree, expand
4.
Select
.
Rib
5.
Add or modify the parameters as specified in Table 43 on page 70.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
1.
2. Enter the name of the routing table.
for IPv6 unicast routes,
inet6.0
for IPv4 MPLS.
Device Manager > Devices
tab.
Routing Options
.
Chapter 7: Configuring Routing Options
Expand the
tree and select
rib-group
.
Import Policy
for the IPv4 multicast
inet.1
.
69
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 and is the answer not in the manual?