Configuring Interface Routes (Nsm Procedure); Table 209: Interface Routes Fields - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices

Configuring Interface Routes (NSM Procedure)

Table 209: Interface Routes Fields

Option
Comment
Family
372
You can associate a routing table group with the device's interfaces and specify routing
tables into which interface routes are imported. To define the routing tables into which
interface routes are imported, you create a routing table group and associate it with the
device's interfaces.
To configure interface routes in NSM:
In the navigation tree, select
1.
In the list, double click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Interface Routes
5.
Add or modify the parameters as specified in Table 209 on page 372.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that updated
device configuration to the physical security device for those changes to take effect.
You can update multiple devices at one time. See the Updating Devices section in the
Network and Security Manager Administration Guide for more information.
Function
Specifies the comment for the interface
route.
Specifies the address family as IPv4 or
IPv6.
Device Manager > Devices
tab.
Routing Options
.
Your Action
Enter a comment.
1.
2.
3.
4.
.
.
Expand the
Interface Routes
and select .
Family
Click the New button or select a
family name and click the Edit
button.
Enter the family name and
comment.
Set up the export policy and import
policy.
Copyright © 2010, Juniper Networks, Inc.
tree