Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 119

Table 64: OSPF Configuration Fields (continued)
Option
Comment
Disable
Prefix Export Limit
Rib Group
Route Type Community
Domain VPN Tag
Preference
External Preference
Reference Bandwidth
No RFC 1583
No NSSA ABR
Area
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the comment for OSPF.
Specifies whether to disable the OSPF
configuration.
Configure a limit to the number of
prefixes to be exported.
Specifies the routing table group.
Specifies an extended community value
to encode the OSPF route type
Virtual private network (VPN) tag for
OSPFv2 external routes generated by
the provider edge (PE) router.
Specifies the route preference for OSPF
internal routes.
Specifies the external route preference.
Specifies the reference bandwidth used
in calculating the default interface cost.
Disable compatibility with RFC 1583.
Disabling compatibility with RFC 1583
can prevent routing loops.
Disable compatibility with NSSA ABR.
Enables you to set up the area details
for OSPF.
Chapter 8: Configuring Protocols
Your Action
1. Enter the comment.
1. Specify whether to enable or disable
OSPF.
To enable OSPF, clear the check
box.
To disable OSPF, select the check
box.
1. Enter the prefix export limit or select
from the list.
1. Select rib group from the list.
1. Select route type community from
the list.
1. Enter the domain VPN tag or select
from the list.
1. Enter the preference or select from
the list.
1. Enter the external route preference
or select from the list.
1. Enter the reference bandwidth.
1. Specify whether to configure RFC
1583.
To enable compatibility with RFC
1583, clear the check box.
To disable compatibility with RFC
1583, select the check box.
1. Specify whether NSSA ABR has to
be configured.
To enable NSSA ABR, clear the
check box.
To disable NSSA ABR, select the
check the check box.
103