Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 149

Table 79: Configuring V3 Fields (continued)
Option Function
Target Address Specifies the
management
application's address
and parameters to be
used in sending
notifications.
Copyright © 2010, Juniper Networks, Inc.
Your Action
1. Expand the V3 tree and select Target Address.
2. Click the New button or select an entry and click the Edit button.
3. Configure the following to create and define an entry:
Name—Specify the name to be assigned to the target address.
Comment—Enter a comment for the target address.
Address—Enter the IPv4 or the IPv6 address of the device to receive
traps or informs.
NOTE: Specify an address, not a hostname.
Port—Enter the UDP port number for the SNMP target.
Timeout—Specify the number of seconds to wait for an inform
acknowledgment. If no acknowledgment is received within the timeout
period, the inform is retransmitted. The default timeout period is 15
seconds.
Retry Count—Specify the maximum number of times the inform is
transmitted if no acknowledgment is received. If no acknowledgment
is received after the inform is transmitted the maximum number of
times, the inform message is discarded. The default count is 3 times.
Tag List—Specify an SNMP tag list to be used to define sets of target
addresses.
Address Mask—Specify an address mask to verify the source
addresses for this group of target addresses. An address mask,
combined with the address, defines a range of addresses.
Routing Instance—Specify a routing instance for this SNMPv3 target
address.
Logical System—On routers only, specify the logical system group
for this SNMPv3 target address.
Target Parameters—Specify the message processing and security
parameters to be used in sending notifications to a particular
management target.
Chapter 10: Configuring SNMP
133