Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 32

Table 14: Configuring and Applying Behavior Aggregate Classifiers
Task
Configure behavior aggregate
classifiers for DiffServ CoS.
Configure a best-effort
forwarding class classifier.
Configure an expedited
forwarding class classifier.
16
Select Classifiers.
4.
Add or modify settings as specified in Table 14 on page 16.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Network
and Security Manager Administration Guide for more information.
Action
1. Click Add new entry next to Dscp.
2. In the Name box, type the name of the behavior aggregate classifier—for example,
ba-classifier.
3. In the Import box, type the name of the default DSCP map.
1. Click Add new entry next to Forwarding class.
2. In the Class name box, type the name of the previously configured best-effort forwarding
class—for example, be-class.
3. Click Add new entry next to Loss priority.
4. From the Loss val list, select high.
5. Click Add new entry next to Code points.
6. In the Value box, type the value of the high-priority code point for best-effort traffic—for
example, 00001.
7. Click OK three times.
1. Click Add new entry next to Forwarding class.
2. In the Class name box, type the name of the previously configured expedited
forwarding—for example, class-ef-class.
3. Click Add new entry next to Loss priority.
4. From the Loss val list, select high.
5. Click Add new entry next to Code points.
6. In the Value box, type the value of the high-priority code point for expedited forwarding
traffic—for example, 101111.
7. Click OK three times.
Copyright © 2010, Juniper Networks, Inc.