Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 97

Table 51: Configuring Martian Address Fields
Option
Address
Comment
Allow
Copyright © 2010, Juniper Networks, Inc.
Add or modify the parameters as specified in Table 51 on page 81.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the martian address or the
destination prefix of a series of martian
addresses that are to be allowed or
disallowed.
Specifies the comment for the martian
address.
Enables you to explicitly allow a subset
of a range of addresses that are to be
disallowed.
Chapter 7: Configuring Routing Options
Your Action
1. Click the New button or select a
martian address and click the Edit
button.
2. Enter the address.
1. Click the New button or select a
martian address and click the Edit
button.
2. Enter the comment for the martian
address.
1. Click the New button or select a
martian address and click the Edit
button.
2. Select the check box to allow the
disallowed address. Selecting the
allow option deletes a particular
martian address from the range of
martian addresses.
3. Clear the check box to disallow the
addresses and mark them as a
martian address.
81