Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 111

Table 59: IGMP Configuration Fields
Option
IGMP
Comment
Query Interval
Query Response Interval
Query Last Member Interval
Robust Count
Accounting
Interfaces
Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Function
Specifies the comment for IGMP.
Defines how often the device sends
general host-query messages. .
Defines how long the query
router/switch waits to receive a response
to a host-query message from a host.
Defines how often the device sends
group-specific query messages.
Defines the number of intervals the
device waits before removing a multicast
group from the multicast forwarding
table.
Specifies whether accounting is enabled
for IGMP.
Specifies the interface and the multicast
group that has to be associated with
IGMP.
Chapter 8: Configuring Protocols
Your Action
Enter a comment.
Select the query interval.
Enter the query response interval.
Enter the query last member interval.
Select the robust count.
Select to enable accounting.
1. Expand the tree and select
IGMP
.
Interfaces
2. Click the New button or select an
interface and click Edit button.
3. Select to disable IGMP on the
Disable
interface.
4. Select the version.
5. Specify the Ssm Map .
6. You can enable Immediate Leave
.
Promiscuous Mode
7. You can enable accounting on the
interface.
8. Select the option
Interface > Static
to configure the multicast group to
be associated with the interface.
and
95