Configuring Voip (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 26: Static Configuration Fields
Option
VLAN
Mac

Configuring VoIP (NSM Procedure)

40
Function
Specifies the VLAN to be configured for
static IP.
Media access control (MAC) address, or
hardware address, for the device
connected to the specified interface.
Voice over IP (VoIP) refers to voice communications over the internet or other packet
switched networks. The VoIP feature enables you to configure voice over IP for interfaces.
To configure VoIP in NSM:
In the navigation tree, select
1.
In the Devices list, double-click the device to select it.
2.
Click the
3. Configuration
In the configuration tree, expand
4.
Expand tree and select
5. VoIP
Add or modify as specified in Table 27 on page 41.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
2. Click the New button or select a
3. Enter the name of the VLAN and the
4. Click OK.
1.
2. Click the New button or select a
3. Expand
4. Click the New button or select a Mac
5. Specify the name, comment and the
6. Click OK.
Device Manager > Devices
tab.
Ethernet Switching Options
Interfaces
Expand tree and select
Static
VLAN and click Edit button in
interface.
comment.
Expand Static tree and select
VLAN and click Edit button in
interface.
tree and select
VLAN
and click Edit button in interface.
Mac
next hop.
.
and select VoIP .
Copyright © 2010, Juniper Networks, Inc.
.
VLAN
VLAN
VLAN .
VLAN
.
Mac