Configuring Rstp On Ex-Series Switches (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 65: RIP Configuration Fields (continued)
Option
RIB Group
Send
Traceoptions

Configuring RSTP on EX-series Switches (NSM Procedure)

Table 66: RSTP Configuration Fields
Field
Disable
Bridge Priority
Copyright © 2010, Juniper Networks, Inc.
Function
The routing table group.
Enables you to configure RIP send
options.
Enables you to configure RIP protocol
level tracing options.
EX-series switches use Rapid Spanning Tree Protocol (RSTP) to provide a loop-free
topology. RSTP identifies certain links as point to point. When a point-to-point link fails,
the alternate link can transition to the forwarding state. RSTP provides better
reconvergence time than original STP because it uses protocol handshake messages
rather than fixed timeouts. Eliminating the need to wait for timers to expire makes RSTP
more efficient than STP.
To configure RSTP:
In the navigation tree, select
1.
device for which you want to configure a port mirror analyzer.
In the Configuration tree, expand
2.
Add/modify RSTP settings as specified in Table 66 on page 107.
3.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Function
Specifies whether RSTP must be
disabled on the port.
Specifies the bridge priority.
Your Action
1. Expand the
Group
2. Specify the comment and ribgroup
name.
1. Expand the
2. Specify the send options.
1. Expand the
Traceoptions
2. Expand the
up the file and flag parameters.
. In Device Manager, select the
Device Manager > Devices
.
Protocols > RSTP
Your Action
Click to select the option.
Enter a value.
Chapter 8: Configuring Protocols
tree and select
RIP Rib
.
RIP tree and select Send
tree and select
RIP
.
Traceoptions tree and set
107
.