Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 127

Table 68: VSTP Configuration Fields
Field
VSTP
Comment
Disable
Bridge Priority
Max Age
Hello Time
Forward Delay
Interface
Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Function
Specifies comment for OSPF.
Specifies whether to disable the VSTP
configuration.
The bridge priority determines which
bridge is elected as the root bridge. If two
bridges have the same path cost to the
root bridge, the bridge priority
determines which bridge becomes the
designated bridge for a LAN segment.
Specifies the maximum age of received
protocol BPDUs.
The time interval at which the root bridge
transmits configuration BPDUs.
Specifies how long a bridge interface
remains in the listening and learning
states before transitioning to the
forwarding state.
Specifies the interface to be associated
with VSTP.
Chapter 8: Configuring Protocols
Your Action
1. Expand the tree and select
Protocol
.
VSTP
2. Enter the comment.
1. Expand the Protocol tree and select
.
VSTP
2. Specify whether to disable VSTP.
1. Expand the Protocol tree and select
VSTP .
2. Enter the bridge priority.
1. Expand the Protocol tree and select
VSTP .
2. Enter the max age or select from the
list.
1. Expand the tree and select
Protocol
.
VSTP
2. Enter the hello time or select from
the list.
1. Expand the tree and select
Protocol
.
VSTP
2. Enter the forward delay time or
select from the list.
1. Expand the Protocol tree.
2. Select VSTP and expand the tree.
3. Select .
Interfaces
4. Set up the priority, cost, mode, edge
and specify whether the interface has
to be disabled.
111