Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 132

Table 70: PoE Edit Settings (continued)
Option Description
Disable Specifies that PoE is enabled on the interface.
Priority Lists the power priority (Low or High) configured
on ports enabled for PoE.
Maximum Power Specifies the maximum PoE wattage available to
provision active PoE ports on the switch.
Telemetries Enable logging of PoE power consumption with
the default telemetries settings.
116
Your Action
Select this option to disable PoE on the interface.
Set the priority as High or Low.
Select a value in watts. If no value is specified, the
default is 15.4.
Select this option to log telemetries. Specify the
following:
Disable—Select to disable logging of telemetries.
Interval—The time interval for logging telemetries
Duration—The duration for which telemtries should
be logged.
Copyright © 2010, Juniper Networks, Inc.