Configuring Multipath (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 38: Configuring Multicast Fields (continued)
Option
Ssm Map
Traceoptions

Configuring Multipath (NSM Procedure)

64
Function
SSM mapping translate IGMPv1 or
IGMPv2 membership reports to an
IGMPv3 report allowing you to support
an SSM network without requiring all
hosts to support IGMPv3.
Defines tracing options for the multicast
group. You can also set up the file
management and access control
parameters .
You can configure protocol-independent load balancing for Layer 3 virtual private
networks (VPNs) with load sharing among multiple external BGP paths and multiple
internal BGP paths. You can use forwarding next hops for both the active route and
alternative paths for load balancing.
To configure multipath load balancing in NSM:
In the navigation tree, select
1.
In the list, double-click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Multipath .
5.
Enter the parameters as specified in Table 39 on page 65.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
1.
2. Click the New button or select an
3. Specify the SSM policy for the SSM
1.
2. Set up the file and flag parameters.
Device Manager > Devices
tab.
.
Routing Options
Expand the tree and select
Multicast
.
Ssm Map
SSM map and click the Edit button.
map and the source address.
Expand the Multicast tree and select
the Traceoptions tab.
.
Copyright © 2010, Juniper Networks, Inc.