Configuring Source Routing (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 43: Rib Fields (continued)
Option
Multipath
Static

Configuring Source Routing (NSM Procedure)

Table 44: Source Routing Fields
Option
Comment
Copyright © 2010, Juniper Networks, Inc.
Function
Enables you to configure the multipath
option in the routing table for load
sharing between external BGP and
internal BGP.
Enables you to configure static routes to
be installed in the routing table.
You can configure source routing to specify IP addresses of the devices along the path,
that you want an IP packet to take on its way to its destination.
To configure source routing in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand Routing Options.
4.
Select Source Routing.
5.
Enter the parameters as specified in Table 44 on page 71.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the source
routing configuration.
Chapter 7: Configuring Routing Options
Your Action
1. Expand the tree and select
Rib
.
Multipath
2. Enter the multipath options.
1. Expand the tree and select
Rib
2. Enter the global static route in
Defaults and destination address of
the static route in Route .
Your Action
Enter the comment.
.
Static
71