Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 150

Table 79: Configuring V3 Fields (continued)
Option Function
Target Parameters Specifies the message
processing and security
parameters to be used
in sending notifications
to a particular
management target.
134
Your Action
1. Expand the V3 tree and select Target Parameters.
2. Click the New button or select an entry and click the Edit button.
3. Configure the following to create and define an entry:
Name—Specify the name to be assigned to this group of target
parameters.
Comment—Enter a comment for this group of target parameters.
Notify Filter—Specify the notify filter to be used by this specific set
of target parameters.
Parameters—Configure the entries for this specific set of target
parameters:
Message Processing Model—Specify the message processing model:
None
v1—SNMPv1 message process model
v2c—SNMPv2c message process model
v3—SNMPv3 message process model
Security Model—Specify this group's security model:
None
usm—SNMPv3 security model
v1—SNMPv1 message process model
v2c—SNMPv2c message process model
Security Level—Specify this group's security level:
authentication—Authentication but no encryption.
none—Authentication and no encryption.
privacy—Authentication and encryption.
Security Name—The user name (if USM is used) or the SNMP
community name (if SNMPv1 or SNMPv2c security models are
used) when generating the notification.
Copyright © 2010, Juniper Networks, Inc.