Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 73

Table 36: Configuring Prefix List Fields
Field
Name
Comment
Apply Path
Prefix List Item
Copyright © 2010, Juniper Networks, Inc.
In the navigation tree select Device Manager > Devices and select the device from
1.
the list.
In the configuration tree, expand Policy Options.
2.
Select Prefix List.
3.
Add/Modify the parameters as specified in Table 36 on page 57.
4.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the prefix list.
Specifies the comment for the prefix list.
Indicates that the prefix list should
include all IP prefixes pointed to by a
defined path.
Specifies the prefix list item.
Chapter 6: Configuring Policy Options
Your Action
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the name.
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the comment.
1. Click the New button or select a
prefix list and click Edit button.
2. Select prefix-list.
3. Specify the path.
1. Click the New button or select a
prefix list and click Edit button.
2. Expand prefix-list tree and select
Prefix List Item.
3. Specify the name and comment.
57