Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 45

Copyright © 2010, Juniper Networks, Inc.
Table 19: Configuring and Applying Rewrite Rules (continued)
Task Action
Configure best-effort 1.
forwarding class
2. In the Queue num box, type 1.
rewrite rules.
3. In the Class name box, type the name of the previously configured
4. Click Add new entry next to Loss priority.
5. From the Loss val list, select low.
6. In the Code point box, type the value of the low-priority code point
7. Click OK.
8. Click Add new entry next to Loss priority.
9. From the Loss val list, select high.
10. In the Code point box, type the value of the high-priority code point
11. Click OK twice.
Configure expedited 1.
forwarding class
2. In the Class name box, type the name of the previously configured
rewrite rules.
3. Click Add new entry next to Loss priority.
4. From the Loss val list, select low.
5. In the Code point box, type the value of the low-priority code point
6. Click OK.
7. Click Add new entry next to Loss priority.
8. From the Loss val list, select high.
9. In the Code point box, type the value of the high-priority code point
10. Click OK twice.
Click Add new entry next to Forwarding class.
best-effort forwarding class—for example, be-class.
for best-effort traffic—for example, 000000.
for best-effort traffic—for example, 000001.
Click Add new entry next to Forwarding class.
expedited forwarding class—for example, ef-class.
for expedited forwarding traffic—for example, 101110.
for expedited forwarding traffic—for example, 101111.
Chapter 3: Configuring Class of Service
29