Table of Contents
Advertisement
Table 39: Configuring Multipath Fields
Option
Comment
Vpn Unequal Cost
Configuring Options (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the comment for the multipath
configuration.
Applies protocol-independent load
balancing to VPN routes.
You can configure the types of system logging messages sent about the routing protocols
process to the system log message file. These messages are also displayed on the system
console. You can log messages at a particular level or up to and including a particular
level.
To configure options in NSM:
In the navigation tree, select
1.
In the
list, double-click the device to select it.
2.
Devices
Click the
Configuration
3.
In the configuration tree, expand
4.
Select
.
Options
5.
Enter the parameters as specified in Table 40 on page 66.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
Enter the comment.
1.
2. Enter the comment for the vpn
Device Manager > Devices
tab.
.
Routing Options
Chapter 7: Configuring Routing Options
Expand the
Multipath
tree and select
Vpn Unequal Cost
.
unequal cost configuration and
specify whether both external and
internal BGP paths should be
selected for the multipath
configuration by selecting the Equal
External Internal check box.
.
65
Advertisement
Table of Contents
