Configuring Snmpv3 (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Configuring SNMPv3 (NSM Procedure)

Table 79: Configuring V3 Fields
Option Function
Comment Specifies the comment
for the SNMPv3
configuration.
Copyright © 2010, Juniper Networks, Inc.
You can configure SNMP version 3 (SNMPv3) for message security and access control.
You can configure the entries for the user-based security model (USM) that SNMPv3
uses for message security and the view-based access control model (VACM) that SNMPv3
uses for access control. USM specifies authentication and encryption. USM uses the
concept of a user for which security parameters (levels of security, authentication, privacy
protocols, and keys) are configured for both the agent and the manager. VACM specifies
access-control rules.
To configure the SNMPv3 options in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand SNMP.
4.
Select V3.
5.
Enter the parameters as specified in Table 79 on page 131.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the SNMP settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
Enter a comment.
Chapter 10: Configuring SNMP
131