Table of Contents
Advertisement
Related
Documentation
Configuring Chassis Alarms (NSM Procedure)
12
Table 11: Aggregated Devices Configuration Details
Task
Configure properties for
Ethernet aggregated
devices.
Configure properties for
sonet aggregated devices.
Configuring Chassis Alarms (NSM Procedure) on page 12
Configuring a T640 Router on a Routing Matrix (NSM Procedure)
Configuring Routing Engine Redundancy (NSM Procedure) on page 13
Configuring a Routing Engine to Reboot or Halt on Hard Disk Errors (NSM Procedure)
You can configure the chassis alarms for an interface type to trigger a red or yellow alarm
or to ignore an alarm. Various conditions related to the chassis components trigger yellow
and red alarms.
To configure chassis alarm on the router:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Alarm.
3.
Add or modify the alarm settings as specified in Table 12 on page 13.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Ethernet next to Aggregated Devices.
2. Enter the number of aggregated logical devices available to
the router.
Range: 1 through 256 devices
3. Click Lacp next to Ethernet.
4. In the System Priority box, enter the priority for the aggregated
Ethernet system.
5. Click Link Protection next to Lacp.
6. Select the Non Revertive check box if you want to disable the
ability to switch to a better priority link (if one is available) once
a link is established as active and a collection or distribution is
enabled.
1.
Click Sonet next to Aggregated Devices.
2. From the Device Count list, select the number of aggregated
logical devices available to the router.
Range: 1 through 16 Devices
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
