Configuring A Bgp Export Policy Condition (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 32: Community Configuration Details
Option
Name
Comment
Invert Match
Members

Configuring a BGP Export Policy Condition (NSM Procedure)

52
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the community.
Specifies the comment for the
community.
Enables you to invert the results for the
community expression.
Specifies one or more community
members.
You can define a routing policy condition based on the existence of routes in specific
tables for use in a BGP export policy.
To configure condition in NSM:
In the navigation tree, select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Click the Configuration tab.
3.
In the configuration tree, expand Policy Options.
4.
Select Condition.
5.
Add or modify the parameters as specified in Table 33 on page 53.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
Your Action
Enter the name.
Enter the comment.
Select the check-box if you want to
invert the results. Clear the check-box if
you do not want to invert the results.
1. Select Members.
2. Click the New button or select a
member and click the Edit button.
3. Enter the member community.
4. Click OK, then click OK again.
Copyright © 2010, Juniper Networks, Inc.