Table of Contents
Advertisement
Table 55: Configuring Bfd Fields
Field
Comment
Traceoptions
Configuring BGP (NSM Procedure)
88
In the navigation tree select
1.
list.
In the configuration tree, expand
2.
Select
.
3.
Bfd
Add/Modify the parameters under the respective tabs as specified in Table 55 on
4.
page 88.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for Bfd.
Enables you to define tracing operations
that track all routing protocol
functionality in the device. You can
configure the tracing flag, filter, and the
tracing policy.
Border Gateway Protocol (BGP) is used for exchanging routing information between
gateway hosts/internet service providers. The routing information refers to the routing
tables containing information about the list of known devices, the addresses they can
reach, and a cost metric associated with the path to each device so that the best available
route is chosen. The primary function of a BGP speaking system is to exchange network
reachability information with other BGP systems. This feature enables you to configure
BGP peering sessions.
To configure BGP in NSM:
In the navigation tree select
1.
list.
In the configuration tree, expand
2.
Device Manager > Devices
Protocols
.
Your Action
Enter the comment.
1.
Expand the
Traceoptions
2. Expand the
up the file and flag parameters.
Device Manager > Devices
.
Protocols
Copyright © 2010, Juniper Networks, Inc.
and select the device from the
tree and select
Bfd
.
tree and set
Traceoptions
and select the device from the
Advertisement
Table of Contents
