Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 94

Table 49: Flow Route Fields (continued)
Option
Name
Comment
Match
Then
Validation
Comment
Traceoptions
78
Function
Specifies the name of the flow route.
Specifies the comment for the flow
route.
Specifies the conditions that the packet
must match for the packet to be
included in flow route. Match conditions
are:
Destination Port
DSCP
Fragment
Icmp Code
Icmp Type
Packet Length
Port
Protocol
Source Port
Tcp Flag
Enables you to specify the action to take
if the packet matches the conditions you
have configured in the flow route.
Specifies a comment for the validation
procedure. Flow routes are installed into
the flow routing table only if they have
been validated using the validation
procedure.
Enables you to define tracing operations
that track all routing protocol
functionality in the device and specify
that tracing results be saved in a log file.
You can configure the tracing flag, filter,
and the tracing policy.
Your Action
1. Expand the tree and select
Flow
.
Route
2. Click the New button or select a flow
route and click the Edit button.
3. Enter the flow route name.
1. Expand the Flow tree and select
.
Route
2. Click the New button or select a flow
route and click the Edit button.
3. Enter the comment for the flow
route.
1. Expand the tree and select
Route
.
Match
2. Enter a comment for Comment
destination address for Destination
and a source address for
Source
3. Configure the match conditions.
1. Expand the Route tree and select
Then .
2. Configure the then conditions for the
packet.
1. Expand the tree and select
Flow
.
Validation
2. Enter the comment for the validation
procedure.
1. Expand the tree and select
Validation
.
Traceoptions
2. Expand the Traceoptions tree and
configure the file and flag
parameters, and the tracing policy.
Copyright © 2010, Juniper Networks, Inc.
, a
,
.