Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 41

Copyright © 2010, Juniper Networks, Inc.
Table 18: Interfaces Configuration Fields (continued)
Option
Shaping Rate
Unit
Interface Set
Name
Comment
Internal Node
Chapter 3: Configuring Class of Service
Function
Shapes the output of the
physical interface, so that the
interface transmits less traffic
than it is physically capable of
carrying.
Sets the units that need to be
allocated to the specific
forwarding class and
scheduling map.
Specifies the interface set
name.
Specifies the comment for the
interface.
Sets the scheduler node as
internal, allowing resource
scheduling to be applied
equally to interface sets that
include child nodes and those
that do not include child
nodes.
Your Action
1. Click the New button or
select an interface and
click the Edit button in
Interface.
2. Expand Interface tree and
select Shaping Rate.
3. Specify the comment and
the rate
4. Click Ok.
1. Click the New button or
select an interface and
click the Edit button in
Interface.
2. Expand Interface tree and
select Unit.
3. Specify the Unit,
Classifiers, Output Traffic
Control Profile and
Shaping Rate.
4. Click Ok.
1. Expand the Interfaces tree
and select Interface Set.
2. Click the New button or
select an interface set and
click the Edit button.
3. Select the name from the
list.
1. Expand the Interfaces tree
and select Interface Set.
2. Click the New button or
select an interface set and
click the Edit button.
3. Enter the comment.
1. Expand the Interfaces tree
and select Interface Set.
2. Click the New button or
select an interface set and
click the Edit button.
3. Set the internal node.
25