Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 157

Table 82: Configuring Community Fields
Option
Name
Comment
View
Authorization
Client List Name
Copyright © 2010, Juniper Networks, Inc.
In the configuration tree, expand
4.
Select .
Community
5.
Click the or icon.
6. Add Edit
Enter the parameters as specified in Table 82 on page 141.
7.
Click one:
8.
OK —To save the changes.
—To cancel the modifications.
Cancel
Apply —To apply the SNMP settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the community.
Specifies the comment for the
community.
Specifies the view associated with the
community.
Specifies the type of access granted to
the community. Access is authorized for
SNMP Get, GetBulk, GetNext, and Set
requests.
Specifies a client list or prefix list to be
assigned to an SNMP community.
.
SNMP
Your Action
Enter a name for the community.
Enter a comment.
Enter a name for the view.
Select an access type for the
community:
None —No requests are enabled.
—Enable Get, GetNext, and
read-only
GetBulk requests. This option is
enabled by default.
read-write
including Set requests.
You must configure a view to enable
Set requests.
1. Expand the
select
Client List Name
2. Select a name.
Chapter 10: Configuring SNMP
—Enable all requests,
tree and
Community
.
141