Configuring Redundant Trunk Links (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 22: Analyzer Configuration Fields
Field Function
Input
Ingress Specifies interfaces or VLANs for which entering traffic is
mirrored.
Egress Specifies interfaces for which traffic exiting the interfaces
is mirrored.
Output
Interface Specifies the interface on which traffic exiting is mirrored.
Vlan Specifies the VLAN on which traffic exiting is mirrored.

Configuring Redundant Trunk Links (NSM Procedure)

36
Select Analyzer.
4.
Click the Add icon.
5.
Add/modify member settings for the interface as specified in Table 22 on page 36.
6.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Simplify the convergence configuration in a typical enterprise network by configuring a
primary link and a secondary link on trunk ports. If the primary link fails, the secondary
link automatically takes over without waiting for normal STP convergence.
To configure redundant trunk links:
In the navigation tree, select Device Manager > Devices. In Device Manager, select
1.
the device for which you want to configure redundant trunk links.
In the Configuration tree, expand Ethernet Switching Options.
2.
Select Redundant Trunk Group > Group.
4.
Click the Add icon.
5.
Add/modify settings as specified in Table 25 on page 38.
6.
Add/modify settings for the VLAN as specified in Table 23 on page 37.
Your Action
Click Add and select Port or VLAN. Next,
select the interfaces or VLANs.
Click Add to add egress interfaces.
Select the interface.
Select the interface.
Copyright © 2010, Juniper Networks, Inc.