Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 135

Table 72: Configuring Client List Fields
Option
Name
Comment
Client Address List
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Enter the parameters as specified in Table 72 on page 119.
7.
Click one:
8.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the SNMP settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the names of the client list that
you are configuring to have SNMP access
privileges.
Any SNMP requests entering the device
from client lists other than the ones
listed for the community are discarded.
Specifies the comment for the client list.
Specifies the addresses of SNMP clients
that are authorized to access this device.
Configuring SNMP Communities (NSM Procedure) on page 140
Chapter 10: Configuring SNMP
Your Action
Enter a name for the client list.
Enter the comment.
1. Click the New button or select a
client address and click the Edit
button.
2. Configure the following to create and
define a client address list:
Name—Enter an IPv4 or IPv6
address for each client.
Comment—Enter a comment for
the IPv4 or IPv6 address you
specified.
Restrict—Select this check box to
deny the specified SNMP client list
access to the device. If you leave
the Restrict check box cleared by
default, access is permitted for
this particular client list.
119