Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual page 164

Table 85: VLAN Edit Settings (continued)
Option Description
Description Describes the VLAN.
Vlan ID The identifier for the VLAN.
L3 Interface Specifies the Layer 3 interface on trunk ports to allow
the interface to transfer traffic between multiple
VLANs.
Mac Limit Specifies the MAC address limit.
Mac Table Aging Time Specifies the maximum time that an entry can
remain in the forwarding table before it 'ages out'.
Filter
Interface
148
Specifies the VLAN firewall filter that is
applied to incoming and outgoing
packets.
Specifies the interface to be added to
the VLAN.
Your Action
Enter a brief description for the VLAN.
Type a unique identification number from
through . If no value is specified, it
4094
defaults to 0.
Type the L3 interface.
Select a value from the list.
Type the number of seconds from
.
1000000
To specify an input and output filter:
1. Click .
Filter
2. Specify the filter to be used for
incoming and outgoing packets.
To add an interface, click
Specify the interface to be included as
part of the VLAN.
Copyright © 2010, Juniper Networks, Inc.
1
through
60
.
Interface