Figure 35: Adding The First Member To A J Series Cluster; Modeling The Cluster Members - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
Click OK.
3.
The new cluster appears in the Device Manager.

Modeling the Cluster Members

Right-click on the cluster icon and select New > Cluster Member from the list.
1.
In the New Cluster Member dialog box, enter a name and color for the cluster member,
2.
and select the Model Device radio button.
Check the Keep Adding Other Cluster Members box and leave the Member ID as 0.
3.

Figure 35: Adding the First Member to a J Series Cluster

Click Next to finish adding the first member.
4.
A plus sign appears next to the cluster icon in the Device Manager indicating that
the cluster now has members. The New Cluster Member dialog box re-appears for
the second cluster member, as shown in Figure 35 on page 171.
Enter a name and color for the second member and select Model Device,
5.
Leave the Keep Adding Other Cluster Members box unchecked.
6.
Set the Member ID to 1.
7.
Chapter 4: Adding Devices
161