Table of Contents
Advertisement
Meaning
Copyright © 2010, Juniper Networks, Inc.
This excerpt from the command output shows the label information displayed when a
circuit is up
host1#show mpls l2transport interface
...
Out Label 49 on
tun mpls:lsp-de090100-24-37
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
...
To display summary information about MPLS shim interfaces:
host1#show mpls interface shim brief
Remote-PE
or
Interface
LSP-name
-----------------
---------
FastEthernet2/0.1
222.9.1.3
FastEthernet2/0.2
222.9.1.3
Table 107 on page 567 lists the show mpls interface and show mpls l2transport interface
command output fields
Table 107: show mpls interface and show mpls l2transport interface
Output Fields
Field Name
MPLS shim interface
Remote PE address
Virtual circuit ID
Group ID
Control word
Sequence number
Relay format
ATM VPI/VCI range
ATM cell aggregation
Chapter 10: Monitoring Layer 2 Services over MPLS
Virtual
Load
Circuit
Balancing
ID
Group
-------
---------
200001
-
200002
-
Field Description
Interface specifier
Address of the remote PE router for the layer 2 circuit
VC ID number for the interface
Group ID number for the interface
Configuration of the control word
Statement regarding configuration of sequence number
Configuration of relay format
Starting and ending (inclusive) virtual path identifiers and virtual
circuit identifiers of the reserved VC range and whether the range
specification is activated on the line module for transportation of
ATM cells that belong to multiple VCs over a single pseudowire.
Concatenation of multiple ATM cells to be sent in a single
MPLS-labeled packet for an ATM port, enabled or disabled.
Admin
Oper
state
state
-------
-----
enabled
up
enabled
up
567
Advertisement
Table of Contents
Troubleshooting
