Table 107: Show Mpls Interface And Show Mpls L2Transport Interface Output - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Meaning
Copyright © 2010, Juniper Networks, Inc.
MPLS policy input shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
MPLS policy output shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
This excerpt from the command output shows the label information displayed when a
circuit is up
host1#show mpls l2transport interface
...
Out Label 49 on tun mpls:lsp-de090100-24-37
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
...
To display summary information about MPLS shim interfaces:
host1#show mpls interface shim brief
Remote-PE
or
Interface LSP-name
----------------- ---------
FastEthernet2/0.1 222.9.1.3
FastEthernet2/0.2 222.9.1.3
Table 107 on page 575 lists the show mpls interface and show mpls l2transport interface
command output fields
Table 107: show mpls interface and show mpls l2transport interface
Output Fields
Field Name
MPLS shim interface
Remote PE address
Virtual circuit ID
Group ID
Control word
Chapter 10: Monitoring Layer 2 Services over MPLS
Virtual Load
Circuit Balancing
ID Group
------- ---------
200001 -
200002 -
Field Description
Interface specifier
Address of the remote PE router for the layer 2 circuit
VC ID number for the interface
Group ID number for the interface
Configuration of the control word
Admin Oper
state state
------- -----
enabled up
enabled up
575