Mpls Lsps For Vpws Overview; Configuring Mpls Lsps For Vpws - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

JunosE 11.2.x BGP and MPLS Configuration Guide

MPLS LSPs for VPWS Overview

Configuring MPLS LSPs for VPWS

Related Topics
658
Configuring BGP-MPLS Applications on page 383
address-family l2vpn
address-family vpws
exit-address-family
neighbor activate
neighbor next-hop-self
neighbor remote-as
neighbor update-source
router bgp
As part of a VPWS L2VPN configuration, you must create MPLS label-switched paths
(LSPs) to connect the local PE router and the remote PE router.
This section explains one way to create a basic MPLS configuration using the mpls and
mpls ldp commands.
To configure MPLS LSPs on the PE router:
Enable MPLS on the virtual router.
1.
host1(config)#mpls
Configure the core-facing interface on which you want to enable MPLS, Label
2.
Distribution Protocol (LDP), and topology-driven LSPs.
host1(config)#interface atm 5/0.100
host1(config-subif)#atm pvc 100 1 100 aal5snap 0 0 0
host1(config-subif)#ip address 192.168.5.5 255.255.255.0
Enable MPLS on the core-facing interface.
3.
host1(config-subif)#mpls
Enable LDP and topology-driven LSPs on the core-facing interface.
4.
host1(config-subif)#mpls ldp
host1(config-subif)#exit
Configuring MPLS on page 275
atm pvc
interface atm
ip address
mpls
Copyright © 2010, Juniper Networks, Inc.