Table 67: Show Ldp Interface Output Fields - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

Meaning
Copyright © 2010, Juniper Networks, Inc.
host1#show ldp interface
Interface ATM6/0.120
Interface address: 192.168.12.1/28
Enabled with profile 'default'
Configured hold time: 15
Hello interval: 5
Hold Time: 1
242 hello received, 242 hello sent, 0 hello rejected
1 adjacency created, 0 adjacency deleted,
Number of adjacencies = 1
Link hello adjacency: Address: 10.10.12.2, Transport address: 80.0.2.2,
Up for 00:20:09, Remaining hold time: 11 sec
To display brief information about LDP interfaces:
host1#show ldp interface brief
Interface IP-Address
ATM6/1.1 192.168.100.21/30
ATM6/1.3 192.168.100.17/30
ATM6/1.5 192.168.100.13/30
ATM6/0.7 172.16.100.1/30
ATM6/0.8 172.16.100.22/30
ATM6/0.9 172.16.100.14/30
NOTE: The mpls keyword is optional and is provided for compatibility with non–E Series
implementations.
Table 67 on page 335 lists the show ldp interface command output fields.

Table 67: show ldp interface Output Fields

Field Name
Interface
autoconfigured
Interface address
Enabled with profile
Configured hold time
Hello interval
Hold time
Number of adjacencies
Protocol
enabled
enabled
enabled
enabled
enabled
enabled
Field Description
Identifier of the interface
LDP has been autoconfigured on the interface
IP address of the interface, with address mask
Name of profile with which interface was enabled
Configured period for which a sending LSR maintains a record of
link hello messages from the receiving LSR without receipt of
another link hello message from that LSR, in seconds
Negotiated interval between link-hello packets, in seconds
Lowest configured hold time among all neighbors on the same
subnet, used as the effective hold time, in seconds
Number of LDP adjacencies for the interface
Chapter 5: Monitoring MPLS
335