JunosE 11.2.x BGP and MPLS Configuration Guide
Enabling BGP Routing
router bgp
Understanding BGP Command Scope
18
All BGP configurations require that you enable the BGP routing process on one or more
routers.
Use to enable the BGP routing protocol and to specify the local AS—the AS to which
this BGP speaker belongs.
All subsequent BGP configuration commands are placed within the context of this
router and AS; you can have only a single BGP instance per virtual router.
Specify only one BGP AS per virtual router.
This command takes effect immediately.
Example
host1(config)#router bgp 100
Use the no version to remove the BGP process.
See router bgp.
BGP commands can be sorted into the following categories, each of which has a different
scope; that is, each configures parameters within a different area of applicability. Individual
command descriptions in this chapter and in "Configuring BGP-MPLS Applications" on
page 383, provide more information about command behavior.
Copyright © 2010, Juniper Networks, Inc.