Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 733

MPLS ping feature
data plane failure detection for egress nodes
IP address in echo request matching with
interface IP address.......................................247
IP address in echo request not matching
with interface IP address.............................247
detection of plane failures
in point-to-multipoint MPLS LSPs at
egress nodes....................................................246
in point-to-multipoint LSPs
type value for Echo Jitter TLV.........................247
P2MP Responder Identifier TLV
checking for receipt of......................................249
relation with traceroute requests
for point-to-multipoint LSPs.........................248
selecting the egress node for tracing path
using IPv4 Egress Address P2MP
Responder Identifier.....................................249
using IPv4 Node Address P2MP Responder
Identifier.............................................................249
using IPv6 Egress Address P2MP
Responder Identifier.....................................249
using IPv6 Node Address P2MP Responder
Identifier.............................................................249
testing connectivity in point-to-multipoint
LSPs, limitation
at branch nodes..................................................246
at ingress nodes..................................................246
at transit nodes...................................................246
using P2MP Responder Identifier TLV
no response to the originator..........................247
success response to the originator...............247
verifying connectivity at egress nodes in
point-to-multipoint LSPs
using Echo Jitter TLV.........................................246
using P2MP Responder Identifier
TLV.......................................................................246
using RSVP P2MP IPv4 Session
sub-TLV.............................................................246
mpls rsvp commands
mpls rsvp...............................................................279, 282
mpls rsvp authentication.........................................294
mpls rsvp authentication key.................................294
mpls rsvp bfd-liveness-detection........................300
mpls rsvp disable.........................................................282
mpls rsvp egress-router............................................279
mpls rsvp profile........................................279, 281, 282
mpls rsvp signalling hello.........................................297
Copyright © 2010, Juniper Networks, Inc.
mpls rsvp signalling hello graceful-restart
recovery-time...........................................................298
mpls rsvp signalling hello graceful-restart
restart-time...............................................................298
mpls rsvp signalling node-hello............................299
mpls-relay atm cell-packing mcpt-timers
command...........................................................................526
mpls-relay atm vpi-range command...........................526
mpls-relay command
prerequisite for configuring
cell concatenation parameters for ATM
ports....................................................................528
VCI/VPI range for ATM VCs
transmission.....................................................527
MTU problems
determining the exact LSR
where size of echo requests exceeds MTU
size.......................................................................379
troubleshooting and verifying in
MPLS LSPs with a Martini circuit..................379
MPLS LSPs with a VPLS instance................379
MPLS LSPs with an IP or IPv6
address...............................................................379
MPLS LSPs with an L3VPN or IPv6
address...............................................................379
MPLS LSPs with an RSVP-TE tunnel..........379
multicast IPv4 address family........................43, 150, 384
multicast IPv6 address family........................43, 150, 384
Multicast LDP FEC Stack sub-TLVs
in echo requests
and Egress Address P2MP Responder
Identifier sub-TLVs........................................250
and Node Address P2MP Responder
Identifier sub-TLVs........................................250
multiexit discriminator, BGP.................................................11
multihoming
for VPLS...........................................................................581
multiple ATM VCs transportation
over a single pseudowire
VPI/VCI ranges....................................................525
multiple ATM virtual circuits
transmission over a single pseudowire
ATMx port state...................................................526
Multiprotocol Label Switching. See MPLS
(Multiprotocol Label Switching)
multiservice layer 2 services..............................................515
Index
697