Table 63: Show Ldp Output Fields - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

Meaning
Copyright © 2010, Juniper Networks, Inc.
LSPs used for IP forwarding
for host addresses only
NOTE: The mpls keyword is optional and is provided for compatibility with non–E Series
implementations.
Table 63 on page 331 lists the show ldp command output fields.

Table 63: show ldp Output Fields

Field Name
LSR ID
FEC Deaggregation
Egress label
Label distribution control
mode
LDP session retry
LDP session hold time
LDP session keepalive
interval
LDP targeted-hello hold
time
LDP targeted-hello interval
Topology Driven LSP
LSPs used for IP forwarding
LDP proto stats
totalPeersDiscovered
totalAdjacenciesEstablished
totalSessionsEstablished
Field Description
IP address of label-switched router
State of FEC deaggregation, on or off
Type of label advertised for the LSR that is the egress router for the
prefix, implicit null, explicit null, or a non-null label
Label distribution control mode used by LDP for label distribution,
independent control, or ordered control
Configured values for the number of LDP session retry attempts
and the retry interval
Configured value for the LDP session hold time
Interval at which LDP sends session keepalive messages, in seconds
LDP targeted-hello hold time, in seconds
LDP targeted-hello interval, in seconds
Status of topology-driven LSP, enabled or disabled
LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LDP protocol statistics
Number of LDP peers discovered
Number of LDP adjacencies established
Number of LDP sessions established
Chapter 5: Monitoring MPLS
331