Table 10: Behavior Of Neighbor Commands; Table 11: Inheritance From Other Commands - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

JunosE 11.2.x BGP and MPLS Configuration Guide
22

Table 10: Behavior of Neighbor Commands

Category A:
Enable or disable a
feature that can be
configured for a peer or
for a peer group
neighbor activate
neighbor
advertise-map
neighbor as-override
neighbor
bfd-liveness-detection
neighbor capability
neighbor
ebgp-multihop
neighbor
ibgp-singlehop
neighbor lenient
neighbor next-hop-self
neighbor
next-hop-unchanged
neighbor passive
neighbor
remove-private-as
neighbor
route-reflector-client
neighbor
send-community
neighbor
soft-reconfiguration
inbound
Some of the commands in Table 10 on page 22 inherit global values set by other
commands. Table 11 on page 22 describes the relationship between these commands.

Table 11: Inheritance from Other Commands

Category B Command
neighbor default-originate
Category B:
Enable or
disable a
feature that
can be
configured
for a peer,
Category C:
for a peer
group, or Set parameters for a peer or
globally for a peer group
neighbor neighbor
default- advertisement-interval
originate
neighbor allow
neighbor
neighbor allowas-in
graceful-
neighbor description
restart
neighbor distribute-list
neighbor
neighbor filter-list
rib-out
disable
neighbor graceful-restart
restart-time
neighbor
shutdown
neighbor graceful-restart
stalepaths-time
neighbor local-as
neighbor
maximum-orf-entries
neighbor maximum-prefix
neighbor
maximum-update-size
neighbor password
neighbor peer-group
neighbor peer-type
neighbor prefix-list
neighbor prefix-tree
neighbor remote-as
neighbor route-map
neighbor send-label
neighbor site-of-origin
neighbor unsuppress-map
neighbor update-source
neighbor weight
Inherits Global Values Set By
default-information originate
Category D:
Set
parameters
for a peer,
for a peer
group, or
globally
neighbor
timers
Copyright © 2010, Juniper Networks, Inc.