Related Topics
Configuring Ethernet/VLAN Layer 2 Services
Related Topics
Copyright © 2010, Juniper Networks, Inc.
Specify MPLS tunneling by using the appropriate command.
2.
host1(config-if)#mpls-relay 10.10.100.2 45 relay-format frame-relay
or
host1(config-if)#route interface tunnel mpls:tunnel6 45 relay-format frame-relay
Configure Frame Relay and MPLS on the remote PE router.
3.
For information about configuring a more complex Frame Relay over MPLS topology,
see Example: Configuring Frame Relay over MPLS on page 543
encapsulation frame-relay ietf
frame-relay interface-dlci ietf
frame-relay intf-type
frame-relay lmi-type
interface serial
mpls-relay
route interface
To configure Ethernet/VLAN layer 2 services over MPLS:
Configure the Ethernet/VLAN interface.
1.
host1(config)#interface fastEthernet 4/0
host1(config-if)#encapsulation vlan
host1(config-if)#interface fastEthernet 4/0.3
host1(confi-if)#vlan id 201
Specify MPLS tunneling by using the appropriate command.
2.
host1(config-if)#mpls-relay 10.10.100.2 45
or
host1(config-if)#route interface tunnel mpls:tunnel6 45
Configure Ethernet/VLAN and MPLS on the remote PE router.
3.
encapsulation vlan
interface fastEthernet
mpls-relay
route interface
vlan id
Chapter 9: Configuring Layer 2 Services over MPLS
531