Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 663

For e series broadband services routers - bgp and mpls configuration
Table of Contents

Advertisement

> 2:1
> 2:1
Copyright © 2010, Juniper Networks, Inc.
2.2.2.2
2.2.2.2
2.2.2.2
2.2.2.2
To display summary information for the L2VPN address family:
host1#show ip bgp l2vpn all summary
Display summary information for the l2vpn address-family
Local router ID 1.1.1.1, local AS 100
Administrative state is Start
BGP Operational state is Up
Shutdown in overload state is disabled
Default local preference is 100
IGP synchronization is enabled
Default originate is disabled
Always compare MED is disabled
Compare MED within confederation is disabled
Advertise inactive routes is disabled
Advertise best external route to internal peers is disabled
Enforce first AS is disabled
Missing MED as worst is disabled
Route flap dampening is disabled
Log neighbor changes is disabled
Fast External Fallover is disabled
No maximum received AS-path length
BGP administrative distances are 20 (ext), 200 (int), and 200 (local)
Client-to-client reflection is enabled
Cluster ID is 1.1.1.1
Route-target filter is enabled
Default IPv4-unicast is enabled
Check next-hops of vpn routes is disabled
Redistribution of iBGP routes is disabled
Graceful restart is globally disabled
Global graceful-restart restart time is 120 seconds
Global graceful-restart stale paths time is 360 seconds
Graceful-restart path selection defer time is 360 seconds
Graceful-restart is not ready to switch to the standby SRP
The last restart was not graceful
Local-RIB version 11. FIB version 11.
Neighbor
AS State
2.2.2.2
100 Established
To display information for the route that matches the specified prefix (2:1) for a VPLS
instance named customer1 in the VPLS address family:
host1#show ip bgp l2vpn vpls customer1 site-id 2 block-offset 1
BGP route information for prefix 2:1
Received route learned from internal peer 2.2.2.2 (best route)
Leaked route
Route placed in IP forwarding table
Best to advertise to external peers
Address Family Identifier (AFI) is layer2
Subsequent Address Family Identifier (SAFI) is unicast
Route Distinguisher (RD) is 100:11
Original Route Distinguisher (RD) is 100:21
MPLS in-label is none
MPLS in-label block size is 0
MPLS out-label is 46
MPLS out-label block size is 20
Next hop IP address is 2.2.2.2 (metric 3)
Multi-exit discriminator is not present
Local preference is 100
100
0 IGP
100
0 IGP
Messages
Up/down time
Sent
00:30:35
65
Chapter 13: Monitoring VPLS
Messages
Prefixes
Received
Received
65
2
627

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2.x

Table of Contents