Table of Contents
Advertisement
CHAPTER 9
Configuring Layer 2 Services over MPLS
Before You Configure Layer 2 Services over MPLS
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure layer 2 services over MPLS on the router, and
contains the following sections:
Before You Configure Layer 2 Services over MPLS on page 529
Configuring Frame Relay Layer 2 Services on page 530
Configuring Interoperation with Legacy Frame Relay Layer 2 Services on page 530
Configuring Ethernet/VLAN Layer 2 Services on page 531
Configuring S-VLAN Tunnels for Layer 2 Services on page 532
Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces on page 533
Configuring Local ATM Cross-Connects with AAL5 Encapsulation on page 534
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation on page 535
Configuring HDLC Layer 2 Services on page 538
CE-Side Load Balancing for Martini Layer 2 Transport on page 539
Example: Configuring Frame Relay over MPLS on page 543
Example: Configuring MPLS L2VPN Tunnel over VLAN over LAG on page 546
Example: Configuring MPLS L2VPN Tunnel over LAG on page 550
Examples: Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport on page 553
Examples: Configuring S-VLAN Subinterface with an Untagged C-VLAN ID on page 557
Example: Multiple ATM Virtual Circuits over a Single Pseudowire on page 559
Before you configure layer 2 services over Multiprotocol Label Switching (MPLS), we
recommend you be thoroughly familiar with MPLS and the type of layer 2 interfaces that
you want to configure.
Before you configure layer 2 services over MPLS, you must configure the layer 2 interfaces
and MPLS.
529
Advertisement
Table of Contents
Troubleshooting
