Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 197

Related Topics
Copyright © 2010, Juniper Networks, Inc.
Table 23: show ip bgp Output Fields (continued)
Field Name
Prefix
Peer
Next hop IP address
MED
LocPrf
Weight
Origin
AS path
Communities
Stale
unicast/multicast routes
selected for route table
installation
unicast/multicast
tunnel-usable routes
selected for route table
installation
tunnel-only routes selected
for tunnel-route table
installation
path attribute entries
Statistics baseline set
Monitoring the BGP Routing Table on page 162
default-fields route
Field Description
Prefix for the routing table entry
Peer from which route was learned
IP address of the next router that is used when a packet is forwarded
to the destination network
Multiexit discriminator for the route
Local preference for the route
Weight of the route
Origin of the route
AS path through which this route has been advertised
Community number associated with the route
Routes that have gone stale due to peer restart
Number of unicast routes in the BGP routing table that have been
inserted into the IP routing table that are also available for use in
the multicast view of the IP routing table
Number of unicast and multicast routes in the BGP routing table
that have been inserted into the IP routing table that are also
available for use in the IP tunnel routing table
Number of routes in the BGP routing table that have been inserted
into the IP tunnel routing table
Number of distinct path attributes stored in BGP's internal path
attributes table. If BGP receives two routes for different prefixes
but with identical path attributes, BGP will create only one entry in
its internal path attribute table and share it between the two routes
to conserve memory.
Timestamp indicating when the statistics baseline was last set
Chapter 2: Monitoring BGP
161