Monitoring Vpls; Setting The Baseline For Vpls Statistics - Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual

CHAPTER 13

Monitoring VPLS

Setting the Baseline for VPLS Statistics

Copyright © 2010, Juniper Networks, Inc.
This chapter describes the commands you can use to monitor and troubleshoot the
virtual private LAN service (VPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and show
commands is identical to output from other E Series routers, except that the E120 and
E320 router output also includes information about the adapter identifier in the interface
specifier (slot/adapter/port).
This chapter contains the following sections:
Setting the Baseline for VPLS Statistics on page 609
Clearing Dynamic MAC Addresses from the VPLS Forwarding Table on page 610
Clearing BGP Attributes for VPLS on page 612
Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance on page 613
Monitoring VPLS Configuration and Statistics for All VPLS Instances on page 614
Monitoring Configuration, Statistics, and Status for VPLS Network Interfaces on page 616
Monitoring Configuration, Statistics, and Status for VPLS Core Interfaces on page 619
Monitoring Configuration, Statistics, and Status for VPLS Ports on page 621
Monitoring MAC Address Entries for a Specific VPLS Instance on page 624
Monitoring Subscriber Policy Rules on page 625
Monitoring Layer2 NLRI for VPLS Instances on page 626
Monitoring BGP Next Hops for VPLS on page 629
Monitoring LDP-Related Settings for VPLS on page 630
Monitoring MPLS-Related Settings for VPLS on page 631
Monitoring VPLS-Specific Settings on page 632
You can use the following baseline commands to set a statistics baseline for a VPLS
instance, for a network interface associated with a VPLS instance, or for the VPLS virtual
core interface associated with a VPLS instance. The router implements the baseline by
609