Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 702

JunosE 11.2.x BGP and MPLS Configuration Guide
Action
host1:pe1# show ip bgp l2vpn vpws l2vpn1
Local BGP identifier 10.1.1.1, local AS 100
2 routes (152 bytes)
2 destinations (152 bytes) of which 2 have a route
2 routes selected for route tables installation
0 unicast/multicast routes selected for route table installation
0 unicast/multicast tunnel-usable routes selected for route table installation
0 tunnel-only routes selected for tunnel-route table installation
4 path attribute entries (608 bytes)
Local-RIB version 6. FIB version 6.
Status codes: > best, * invalid, s suppressed, d dampened, r rejected,
a auto-summarized m multihomed-backup
Prefix Peer
> 1:1 0.0.0.0
> 2:1 12.2.2.2
666
To display layer 2 NLRI for the route that matches a specified prefix (site ID and block
offset) in the L2VPN address family or in the VPWS address family, use the site-id and
block-offset keywords.
To display information for a particular L2VPN instance in the L2VPN address family:
Next-hop MED LocPrf Weight Origin
self
12.2.2.2
To display summary information for a particular VPWS instance in the VPWS address
family; only the BGP operational state is useful:
host1:pe1# show ip bgp l2vpn vpws l2vpn1 summary
Local router ID 10.1.1.1, local AS 100
Administrative state is Start
BGP Operational state is Up
Shutdown in overload state is disabled
Default local preference is 100
Default originate is disabled
Always compare MED is disabled
Compare MED within confederation is disabled
Advertise inactive routes is disabled
Advertise best external route to internal peers is disabled
Enforce first AS is disabled
Missing MED as worst is disabled
Route flap dampening is disabled
Log neighbor changes is disabled
Fast External Fallover is disabled
No maximum received AS-path length
BGP administrative distances are 20 (ext), 200 (int), and 200 (local)
Client-to-client reflection is enabled
Cluster ID is not configured (local router ID used)
Route-target filter is enabled
Default IPv4-unicast is enabled
Redistribution of iBGP routes is disabled
Graceful restart is globally disabled
Global graceful-restart restart time is 120 seconds
Global graceful-restart stale paths time is 360 seconds
Graceful-restart path selection defer time is 360 seconds
Graceful-restart is not ready to switch to the standby SRP
The last restart was not graceful
Local-RIB version 6. FIB version 6.
(No neighbors are configured)
To display information for the route that matches the specified prefix (2:1) for a VPWS
instance named customer1 in the VPWS address family:
0 IGP
100 0 IGP
Copyright © 2010, Juniper Networks, Inc.