Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 531

Copyright © 2010, Juniper Networks, Inc.
Table 96: show ip protocols Output Fields (continued)
Field Name
Routing for Networks
IS-IS
System Id
IS-Type
Distance
Address Summarization
Routing for Networks
OSPF
Router ID
Distance
Redistributing
Address Summarization
Routing for Networks
RIP
Router Administrative
State
System Version
Update interval
Invalid after
hold down time
flushed interval
Filter applied to outgoing
route update
Field Description
The network for which BGP is currently injecting routes
6-byte value of the router
Routing type of the router: Level 1, Level 2
Administrative distance for IS-IS learned routes
Aggregate addresses defined in the routing table for multiple groups
of addresses at a given level or routes learned from other routing
protocols
Network for which IS-IS is currently injecting routes
OSPF process ID for the router
Administrative distance for OSPF learned routes
Protocol to which OSPF is redistributing routes
Aggregate addresses defined in the routing table for multiple groups
of addresses at a given level or routes learned form other routing
protocols
Network for which OSPF is currently injecting routes
RIP protocol state. Enable means it is allowed to send and receive
updates. Disable means that it may be configured but it is not
allowed to run yet.
RIP versions allowed for sending and receiving RIP updates. The
system version is currently set to RIP1, which sends RIP version 1 but
will receive version 1 or 2. If the version is set to RIP2, the system will
send and receive version 2 only. The default is configured for RIP1.
Current setting of the update timer (in seconds)
Current setting of the invalid timer (in seconds)
Current setting of the hold down timer (in seconds)
Current setting of the flush timer (in seconds)
Access list applied to outgoing RIP route updates
Chapter 7: Monitoring BGP/MPLS VPNs
495