Juniper JUNOSE 11.2.X BGP AND MPLS Configuration Manual page 268

JunosE 11.2.x BGP and MPLS Configuration Guide
232
In Received Packets 78, Bytes 5991
Unicast Packets 29, Bytes 2469
Multicast Packets 49, Bytes 3522
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 78, Bytes 5786
Unicast Packets 78, Bytes 5786
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
queue 0: traffic class best-effort, bound to ip ATM9/0.10
Queue length 0 bytes
Forwarded packets 1, bytes 52
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
ip19000001.mpls.ip line protocol MplsMajor is up, ip is up
...
The show mpls interface command displays the queue associated with the MPLS major
interface, but indicates it is bound to the layer 2 interface.
host1:pe1# show mpls interface
MPLS major interface ATM9/0.10
ATM circuit type is 1483 LLC encapsulation
Administrative state is enabled
Operational state is up
Operational MTU is 9180
Received:
1 packet
136 bytes
0 errors
0 discards
0 failed label lookups
Sent:
1 packet
136 bytes
0 errors
0 discards
LDP information:
10.10.10.1/24
enabled with profile 'default'
133 hello recv, 136 hello sent, 0 hello rej
2 adj setup, 1 adj deleted,
Session to 10.10.10.2 is operational (passive)
Session statistics:
4 label alloc, 4 label learned,
4 accum label alloc, 4 accum label learned,
last restart time = 00:01:49
Rcvd: 0 notf, 8 msg, 4 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 8 msgId
0 bad mapping, 0 bad request, 0 bad abort, 0 bad release
0 bad withdraw, 0 bad addr, 0 bad addr withdraw
0 unknown msg type err
last info err code = 0x00000000, 0 loop detected
Sent: 0 notf, 8 msg, 4 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 8 msgId
Copyright © 2010, Juniper Networks, Inc.