Step 6: Configuring The Rdr Formatter Destination - Cisco SCE 1000 Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Note that there is no default for this parameter.
Step 5 You may configure up to three domain servers.
Would you like to add another Name Server? [no]:
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
When IP addresses for all servers have been entered, exit the dialog by pressing Enter.
Step 6
Would you like to add another Name Server? [no]:
E
XAMPLE
Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the
IP address of the Domain Name Server is 10.1.1.230.
Would you like to enter the DNS configuration menu? [no]: y
Enable IP DNS-based hostname translation? [yes]:
Enter default domain name []: pcube.com
Enter Primary DNS IP address: 10.1.1.230
Would you like to add another Name Server? [no]:

Step 6: Configuring the RDR Formatter Destination

The SCE 1000 passes Raw Data Records (RDRs) to an external collection system via the RDR-
Formatter. In order for the data to reach the correct location, the IP address of the external
collection system and its port number must be configured.
To configure the RDR-formatter destination, complete the following steps:
Step 1 Enter the RDR formatter configuration menu.
Would you like to enter the RDR-formatter configuration menu? [no]: y
Type y and press Enter.
The RDR-formatter destination dialog begins.
Type the IP address of the RDR-formatter destination and press Enter.
Step 2
Enter RDR-formatter destination's IP address:
Note that there is no default for this parameter.
Step 3 Type the TCP port number of the RDR-formatter destination and press Enter.
Note that there is no default for this parameter.
Enter RDR-formatter destination's TCP port number:
E
XAMPLE
Following is a sample RDR-formatter configuration dialog, assigning the IP address and TCP port
number.
Would you like to enter the RDR-formatter configuration menu? [no]: y
OL-7821-04
To exit the DNS settings dialog, press Enter.
•
To add another domain server, type y and press Enter.
•
:
:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Initial System Configuration
5-11