Show Classofservice Dot1P-Mapping; Show Classofservice Ip-Precedence-Mapping - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
Format
Modes
13.1.7.1 no traffic-shape
This command restores the interface shaping rate to the default value.
Format
Modes

13.1.8 show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic
classes for a specific interface. The unit/slot/port parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the
802.1p mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed. For more information, see
(IEEE 802.1p) Commands" on page
Format
Mode
The following information is repeated for each user priority.
User Priority
Traffic Class

13.1.9 show classofservice ip-precedence-mapping

This command displays the current IP Precedence mapping to internal traffic classes for a
specific interface. The unit/slot/port parameter is optional and is only valid on platforms
that support independent per-port class of service mappings. If specified, the IP
Precedence mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed.
Format
Mode
The following information is repeated for each user priority.
Quality of Service (QoS) Commands
traffic-shape <bw>
Global Config
Interface Config
no traffic-shape
Global Config
Interface Config
17.
show classofservice dot1p-mapping [unit/slot/port]
Privileged EXEC
The 802.1p user priority value.
The traffic class internal queue identifier to which the user
priority value is mapped.
show classofservice ip-precedence-mapping [unit/
slot/port]
Privileged EXEC
v1.0, October 2008
Section 6.4 "Provisioning
13-5