Managing Users And Security; Managing User Accounts; Types Of Accounts; About "User" Account Permissions - Safran VersaSync User Manual

4.4 Managing Users and Security
4.4

Managing Users and Security

4.4.1

Managing User Accounts

Users need to authenticate as the login to VersaSync. The system administrator is
responsible for maintaining a list of user accounts (user names, passwords etc.)
via the MANAGEMENT > OTHER: Authentication screen of the VersaSync
Web UI (HTTP/HTTPS). Note that user accounts CANNOT be created or edited
via CLI commands using telnet or SSH.
4.4.1.1

Types of Accounts

There are three types of accounts:
Account
Type
"user"
"admin"
"factory"
4.4.1.2

About "user" Account Permissions

As outlined above – unlike "administrator" accounts – "user" accounts are read-
only accounts, i.e. they do not allow any editing rights and are restricted to
reviewing status-related information. Otherwise, the privileges assigned to admin
groups are exactly the same whether logging in via the Web UI, or connecting via
SSH.
Account Differences, General
While most menus look the same to "admin" and "user" type accounts(except the
MANAGEMENT menu, see below), the screens and panels located below the
main menus will differ in such that the "user" UI will show fewer (if any) con-
figuration options:
242
These accounts are intended for users only e.g., operators. These "user" accounts
are read-only accounts, i.e. they do not allow any editing rights and are restricted
to reviewing status-related information. The Web UI will not show (or gray-out)
any editing functionality.
Administrator accounts are intended to be used by system administrators. These
accounts have writing access. You can add additional admin accounts to the pre-
installed administrator account
The default factory account with the username
access to Safran technical support personnel. You can delete this account, if you
so prefer. Note, however, that executing the
recreate the Factory account.
Permissions
spadmin
.
spfactory
Clean and Halt
CHAPTER •
4
is meant to provide
command will
VersaSync User Manual Rev. 12